Page 5 - Leaf Demon OP Manual MultiLanguage
P. 5

USING THE POOL BLASTER LEAF DEMON

For Bottom Cleaning                                             Maintenance

Press the ON/OFF button on the battery box to start the Leaf    ALWAYS clean out the debris bag following each use and
Demon. Using the pool pole, lift the Leaf Demon into the pool   carefully remove any debris that might be stuck in the propel-
and guide it to the pool bottom in the “Wheels Down” position.  ler area of the cleaner.

For Surface Cleaning                                            Remove the batteries from the battery box prior to long-term
                                                                storage (ie. at the end of the pool season).
Push the pole adapter down
until the adapter locks in place.                                           IMPORTANT SAFEGUARDS
Turn the cleaner “ON.”
                                                                1. Extreme care must be taken to avoid fingers,
The Leaf Demon may now be                                       toes, hair or any other body part from coming in
used in the “Wheels Up” posi-                                   contact with the Impeller while the unit is
tion to skim leaves and other                                   operating.
floating debris from the pool’s
surface.                                                        2. Operation of this unit by children and/or
                                                                persons of diminished physical or mental
Adjusting the Clearance Height                                  capacity is not recommended unless they are
                                                                closely supervised by an authorized adult.
The Leaf Demon is packaged
with its clearance height in the                                3. Always check the battery box cap to make
“LOW” position.                                                 sure that it is completely closed before each
                                                                use. If water enters the battery box, it can
The height of the Leaf Demon                                    damage the unit but is not considered a health
can be raised up to 1/4 inch if                                 hazard.
needed by doing the following:
                                                                                                                                             Filter Bag
1. Use a small scewdriver or                                                                                                                 LVAC022AP
pair of needle-nose pliers to
remove the “E”-clip from the
top of the wheel pivot shaft.

2. Remove the wheel pivot                                       Pole Adapter Assembly             Filter Ring
shaft assembly. Don’t lose the                                  LD061                             LVAC056
“E” - clip and spacer.                                                                        Leaf Demon Body
(see Photo).                                                                                  LD915

3. Place the spacer on the
pivot shaft and guide the
shaft back into the body from
beneath.

4. Replace the “E”-clip on the
top of the shaft.

Repeat these procedures on
the remaining 2 wheel pivot
assemblies.

                                                                    Battery Chamber Assembly  Wheel Assembly
                                                                    LD015                     LD050

                                                                4
   1   2   3   4   5   6   7   8   9   10